Assembling the t20 but when placing the center plate it won’t sit flush on the clutch side against the case and gasket. About 1/4 “ raised. Not on the band pin, sun gear and washers all fit below the final c clip. I haven’t tried booting it all together for fear of ruining something but when the two halves are put together it won’t sit flush. I’ve put it together a couple times same thing. Any suggestions? Is my input shaft too far into the case?
First thought is the input shaft is sitting on the bench. I have a hole in mine to place transmission shafts through. If you still don’t see it you can text me at 907-388-8582.
I’ll try it later tonight thanks. Yeah my input shaft/clutch was on the the bench under it. But even when I laid it horizontal and tried to put the two cases together there was a small quarter in gab on the clutch side if I can’t get it I’ll text you I appreciate that.
Dog ear washer not lined up with it's slot?
A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.
When you do go together with the other half I’ve e found a long Phillip’s screwdriver through a bolt hole makes a handle and guide pin. Don’t bolt halves together until sure it’s siting on the gaskets.
I always drop the clutch side of tranny down in the other half. Use the screw driver in a bolt hole to wiggle the two half’s together to get the band pin to drop in the center plate hole with a “clunk”. They can be a bugger sometimes.
This is how i rig mine for assembly.
Make sure the band anchor pin didn't come out of the case side, rather than the center plate. This will keep the halves from seating correctly.
Posting Permissions
Reply With Quote
