Forum: Max ATVs

I have a 2005 Max Iv with 27hp 130 hours and when I rev it and let off I get a clunk from the clutch. What could that be?

Can I keep the cab on while trailering my Max down the road?

This is probably a dead horse, but.... Back in 2016, after I got my MAX II, I had power issues, and after a few posts, I thought that I might have...

just wanted to know if there is a year listed in the serial number

Sarasota, FL, November 29, 2021 – Planet Resource Recovery, Inc. (OTC:PRRY) is pleased to announce that the company acquired MAX Amphibious...

Hi Guys Sorry for the absence, but life and sh_t happens. After I purchased my 1996 MAX II in Nov 2015, I had slowly gone through routine "let's...

One time while out fishing I broke a throttle cable on my IV. Luckily I had a long handled net with. So I hooked the net to the carburetor and pulled...

I know I covered this before on here but still can?t figure it out. In cold weather it clicks but won?t engage. Sometimes it takes 50 plus time?s...

Bought a 1994 Max II with a Briggs 14hp twin. Was a 6 hour drive from home but from the pictures seemed to be worth the gamble. Was not disappointed....

Hi all. So I'm doing a frame out rebuild brought about by some sprocket bolts that broke and worked there way out as they were spinning. Needless to...

Hi guys, I?m in the process of installing a new engine and the mounting bolts don?t line up. I?m going to have to drill new holes and I can?t find...

Well after many years on hold I'm finally going to start work again on my 1980 Max IV serial #6448. Years ago I removed the frame from the body doing...

I've got plastic and I have to trailer every time want to go and they slip all over hell. Don't think max made rubber? Anyway I would like to try...

Earlier this year I acquired a 1989 Max IV in pretty decent shape for $1,500. I plan on completely ‘restoring’ this machine back to perfect running...

Hi, I got my new front axle , the snap ring type that takes a bolt in the inner end with a washer for extra retention. I failed to order the bolt and...

Earlier this year I acquired a 1989 Max IV in pretty decent shape for $1,500. I plan on completely ‘restoring’ this machine back to perfect running...

Hi, I see I have a bent axle on my Max II. It is a 2003 with the 23 hp Kohler Command. Is it possible to still buy the original splined axle or are...

Hello, I haven't posted much...but have read through a fair bit to get my Max IV running (gear train/drive line stuff). If you keep...

Has anyone experimented with changing gear ratio between transmission (15 tooth sprocket) and lower rear axle (34 tooth sprocket)? This gives a 2.26...