Forum: Max ATVs

looking at a 2003 max iv with tracks. like the machine but it only has an 18hp engine. how hard is it to put in a new vanguard 29hp or can you even...

so what do I have to do to clear 25s on my max ll

What cross references with a RI 018036 belt?

Has anyone seen this type of wheel with a built in winch on the rim? I found a max in florida that has one on it for sale on craigslist, here is the...

Hi Guys I have 3 Max II, Two 16HP and one 18HP,All three have Briggs & Stratton V twin Vanguard engines, and time to sell one:bawling: too many...

I have a Max ii and I removed my return springs to adjust my t20 bands and I have been driving it like that around my yard and I really like the...

I have a 1996 Max IV that I purchased about a year ago by one of the members here, Coyote. He did a lot of custom work on the Max and posted his...

I just put on a new heated throttle cable my old one I had set up with 12 volt heat trace it just was not doing the job the new one I installed I...

I'd like to have suspension on my 2008 max 4,, is there one available or do y'all know anyone who can help me out plus I'm having trans trouble,,...

I found what appear to be stress cracks towards the rear of the frame on my '96 Max IV. These were not surface cracks, they went all the way through....

Hi All I was looking at splitting the shift levers and noticed the front right chain after the adjuster, the chain looks like its veing off to the...

Just a walk around of my 1983 Max II project I just started. I haven't been on here in awhile, my dad ended up with the Mule in my sig as his farm...

Hello forum members. I have a 1996 Max II with a 23hp Vanguard engine (new). I purchased and installed a set of 5" wheel extensions from Richard's...

Hi all, I would like to do an inside bearing upgrade in the spring. I was wondering if it can be done with hollow axels. If so, how would you go...

Could a hockey puck be bored out and drilled and be used as a synthetic outer bearing? Looks like hockey pucks are made out of vulcanized rubber,I...

Hi guys!! Have an old max with the 2 stroke jlo and I need a drive belt number or brand.I have no serial # to give but it has the inner bushings on...

I need to build a custom frame rail to finish off my track setup. I'm using Max II bearing cages on a Max IV. The outer part of the cage has three...

I recently purchased a 2003 Max iv 900t with the 25 hp kohler. I have found that the drive belt is way too loose. I can easiliy touch the belt...

I was up at Recreatives today and Hey_Dan78 and I snapped some pictures of a very early and rare prototype Max II that DID NOT USE THE T-20. As Dan...