Forum: Max ATVs

Just picked up a max iv .... it has Carlisle 23x10.50-12, is this a common wheel/tire combo for the older ATVs? The research I’ve been doing is...

I am new to the max II and just restored one. I was wondering what drain plugs I should use?

Redoing all bearings and flanges on my max iv. Anyone try a rubber gasket on the outer flanges? Thinking about rubber gasket with 3m 4200.

Looking to get information on my max II. Looking for a year, correct motor suppose to be in it, where to find parts. Serial number is 6250. Motor is...

I'm very new to all this, but am hoping to get some help figuring this out. I have a MAX IV (year unknown...all the plates are spray painted...

Somebody wrote about the bolts on the band clevis's being too short after replacing the bands in the t20 tranny, well i came across the same issue...

I have a max II that the two forward bands are worn out. I don't have a lot of funds so need to replace only the bad parts. Is there just left and...

I've been trying to do as much research on tires as I can, i have a early 90s model MAX IV, in desperate need of tires. The tires on it now are...

I have a 1991 max II and the transmission has never been touched other than fluid changes. I was wondering when it needed to be rebuilt. The right...

I just picked up a 1991 max II and the chains are tightened but they still hit the bottom of the tub. Do I need to replace the chains?

I’m looking into doing a transmission change on a 1991 max II. I’m going to use a pump but I don’t know what type of pump to use or what brand...

I did a engine swap on the max im restoring.put a 16 hp bs vanguard in replaced the old single lung teschuma, the swap was minimally evasive...

Just curious what Max RPM range people are running to get to top speed and how much of a difference does an RPM range of 3500 vs 4000 have on top...

Just got a Max II it has two ballon tires on front three lug any one know what these are worth no cracks and they hold air. :hmmmm2:

My max ii has the old style lower tub, I was wanting to eventually run 24 or 25 inch tires but it's looking pretty tight around the front...

I thought I should repost this since I was wrong about the part I was trying to get info on it's not the Ring gear drum (sorry)