Forum: Engines

Hey guys I purchased a 99 conquest a couple months ago,I was changing a front axle and bearing and happened to check the oil while I was standing...

I'm planning to purchase a 14-16 hp Briggs for a Max 6x6 project. A forum member advised me to avoid the Intek engine. I haven't been able to reach...

Could anybody tell me the shaft size of a Kohler CH20. Are the shaft sizes all the same or do they vary depending on application? I'm looking to get...

I can't find one anywhere

I just traded for a 2000 Argo conquest with the kawasaki 20. First day it ran good for a while then began to die and we would have to choke it to get...

Hellow, I new to the site, I would like to increase the RPM of the Kohler non EFI engine just slightly for a bit more power and higher top speed....

does anyone know where to get a magnum 20 carburetor rebuild kit?

Does anyone have an oil temp gage installed on their machine? If so,what are some of the typical temp readings you experience? Thanks, Joe.

I recently purchased an old Hustler with a CCW 340 . Overall it runs well, but it does not like to start, especially when cold, and seems to have an...

I have a single cylinder sachs motor in my Amphicat. I just rebuilt the carb. It will run great when you first start. I drove it around a while made...

I have a 6x6 that was given to me its got a rockwell engine.I need a wireing digram because the wireing harness is gone. Will some one plz help me. ...

I just found a website that specializes in these old motors. If you need any parts, try giving them a call. Growth Products, Inc. Growth Products...

Ok so on my recently free argo, I've discovered the motor in it is a Chapparal G44b. This thing has probably been sitting for about 20 yrs. I got it...

ya ya i know,4 wheelers are the enemy lol.my poor old honda foreman has an electrical issue.starter wont turn engine over unless i jump the...

I had a new exhaust made for my max which uses 1.5'' pipe in to a car muffler on its side centered on the side where the pull start is. question is...

I've got a 400cc kohler motor with a tillotson HR carb on it. I just put a carb kit in it and I thought it would work. When I put gas to it, it...

I just got a 6 wheel max I have a rockwell jlo 440 I want to drop in it but I have a problem its only banging on one cylinder I switched coils around...

Hi guys, Managed another Bargain on Ebay 1 and a half engine :top: 1 complete Briggs Vanguard 21hp and the majority of another. I've done a...