Forum: Engines

Just putting this into the 6x6world.com knowledge base. other search terms: anti-backfire fuel-shutoff If you choose to replace with a bolt you...

just put in a new mtr brigs v twin 18hp. with mtr running volt meter on bat how manny volts should meter show? the meter showes to jumping all...

Can anyone tell me which engine the briggs carb part # 809011 fits? :hmmmm2: I can't seem to find this anywhere (incorrectly assumed it would be...

Since I dont have a manual for my engine. Other than the air cleaner filter and the fuel line filter. Is there any other filter I might be missing? ...

So i'm repowering my old 70's argo with a new 18hp briggs vanguard engine. The machine had a 16hp tejunksy in it originally. My concern is with...

Was wondering if I wonted to get a little more hp out of my 16 hp Briggs what would be the easiest way to get it or can this even be done?

why have i never heard of putting a street bike motor in one and have 12 diff speeds be unlimited low end torq for the tracks im getting ready to...

Scat Male/Female engine mount Just found these, someone may need a few.

Are there any typical leak spots on a Vanguard V-Twin? My 14 Hp leaks as soon as I add oil (that explains the oil in the tub when I bought it... I...

Had the engine in and out twice today setting points and timing. Runs good now but it's too late for a drive. Check out the video.....the audio is...

:hmmmm2:What's the most cost effective way to bump-up the HP and torque of the carbureted Kohler command series engines without excessively...

ok got a duromax 4 stroke engine, still lookin for a clutch does anyone know and have some pics on how to set up a trhottle on these? the factory one...

Motor will start and run but backfires and won't idle also does not want to go in high gear bogs down. What could this be? Just cleaned carb and new...

Does any body have a wiring diagram for the Attex wiring harness? I am trying to find out which wire in the ignition switch turns the engine off. I...

having problems getting my jlo to fire. coils tested good, new condensers and points. i have good ground at coils, also have good signal thru black...

So seeing videos of some of you guys spinning wild doughnuts and slinging mud all over the place has me feeling less faithful to my old opposed 18HP...

Looking to see if anyone has had this problem? I installed an 18 hp Briggs in a Max 11,, I started the engine and run it for about 2 minutes, just...

Can anybody tell me The Briggs stratton part # for the governor spring black its the one that gos to throttle and governor argo part #805458. A...