Forum: Engines

Im looking to replace the engine on my 1968 tt-10 terra tiger. Would an older cast iron black 4 stroke work or would that be to heavy for the...

Hello. I came across a Max II that has a Duro Max 16hp engine. It has twenty hours on it. How do these compare to Brigs&Statton engines? Is it...

Hi there. Just picked up a 95 max in great condition. Only problem I have is the motor stalling out after I hit a few good bumps. I pull the choke...

Does any body have the part # on a carb rebuild kit for a 16 hp briggs in a 2009 max 2

Got the engine running and starting good (man this things fast for a newbie), now i just gotta get the charging system working. Looking at the...

:hmmmm2:My gas cap on my six was bad so I went to Fleet Farm and bought a new one. I didn't drive my wheeler for about 2 weeks. I went out riding and...

I am looking at installing a Bandolero in my argo. Is there any down side to running this motor in a AATV? Do you have to run racing gas, do they...

trying to figure out what sachs motor my amphicat has thought it was a 292 but i can only find a Arctic Cat 292. im in need of a new head gasket...

I was riding around in my 2005 argo avenger for about an hour. Stopped the engine from running for about 20 minutes. Started the engine and found out...

I don't have a tach, and I dont like doing it by ear. So I found this method, unfortunately my multi meter dosn't do Hz. I would be interested to...

I found with my new 23 hp engine that it doesn't start right away. It takes alot to get it started but once started during the day it starts mostly...

What size bolt do I need to make a puller for my 295 JLO / Salisbury clutch? It looks to be about 22mm x 1.75 thread. That is not a common bolt size....

I read somehwere here, about a work around in the case of a failed FD620D starter. Can someone provide more details and perhaps some pictures to...

Over the winter I purchased an old Argo 6 Wheel that had been sitting in a garage for the past 15 years without being used or started.....it is in...

Guys--this one stumps me--98 kawasaki conquest. Runs like it should for many hours, then for no reason won't start. First time tried everything, carb...

picked up a 1970 hustler 880 with a ccw400 over the weekend. The guy i bought it from said it was pull start only. I didnt think that sounded right,...

Can anybody tell me why both pushrods on number one cylinder are bent I recently picked up this argo and it was sitting for a while but I changed the...

My Engine 'skips' at idle, Im going to change the plugs, what else could it be? Also, When I trottle ups and release, in neurtral, I get small...

starts fine, idles good, I can rev the RPMs, but when i put it under a load it skips. Bad Gas, Sticky Valve? any suggestions or ideas please.