Forum: Engines

Hi, just purchased an Argo 2012 Frontier 650. 40 hours. It sat in a shed for 5 years. Previous owner couldn’t start it so bought new carb to get it...

JLO 252 in a crazy colt. Looking for spark plug recommendations. Manual says OEM is Champion K9. Through google ive found a list of supposed...

Is it possible for a bad starter to fry solenoids? I started my 97 Max IV and it ran great. After turning it off I couldn't restart the engine with...

I have a Mikuni 38 mm carb on a Chaparral GB50. It everything works great until I open the throttle up. Then gas starts dribbling out of the...

I checked the voltage while it was running and it was only 12.4 volts, which is battery voltage, anyone know what it should put out? I have never had...

Hi all ...I really need some answers here ..been asking everywhere . I have a vanguard 16 hp I want to put in my 78 8 or 6 wheeler. Taking...

Is it possible to test a voltage regulator? Working on a G50B. I have installed a new stator. I get 12 volts at idle and about 12.8 volts at half...

Well went to pull the plug on my hustler Kohler 16 hp. and well busted off. So easy enough pulled the head off to make it easier to remove broken...

Curious to see what jet sizes are being run in the VM38 on a G50B? The one I have is stock with the exception of the. 20 over pistons.

I am looking for the float height for the VM 38 on a G50B. I started with 21/32 and gas would flow out of the over flow tube at idle. I have pulled...

Hi all, I'm hoping someone has an answer to my problem. I had a brand new carb installed in my ATV and it seemed to run well but began sputtering...

Attex 252 Crazy Colt JLO L252L, Mtr# 25222090 I have spark at the ignition cable to cylinder head but not spark plug when connected and grounded...

Recently picked up a conquest with the Kawasaki Fd620d. A few things are odd. Symptoms: Idles very low, but starts very well even in cold...

Hi. What are people using for replacement choke cables for engines with Mikuni carbs?

Hey y’all. Down here in texas I’m very lucky to have gotten my hands on a snow mobile motor. First one, very cool! Just got my hustler fully...

Hey guys my conquest smokes pretty heavily once it’s idled for a couple minutes. When you take off it is chugs for a minute. Then it runs fine, no...

Wondering what 4 stroke engines have been swapped into amphicats. I've read as low as 6.5hp. I'm swapping soon, and trying to decide on engines, I'm...

Hi. Can someone tell me how the Condenser is held in to the stator plate on a JLO 400? Is it just pressed in? I ordered new ones, but cannot seem...

when yall do an engine swap how loose / tight is belt tension supposed to be? i may have worded this a little odd, but i figure engine - trans...