Forum: Engines

I know there are alot of us that wish we had MORE POWER for are 6x6's. So I started this thread to see what we could find out. What motor would you...

Is there any difference between the 440 cuyuna and the jlo,rockwell. Will they bolt right up to where a g50b was or is there modifications that have...

Whats The Parts Availability For The 484cc Like Out There In Resto. Land?

Hi all I am new to the aatv world but im loving it. I have a Max4 with a 18 hp Briggs in it. I was looking to put a new Kawasiki 25 hp liquid cooled...

Hey Guys, My 440 Kohler has become almost impossible to start, and if I do get it started, I can't get a good carb adjustment on it. It's all over...

Hey Guys, Any recommendation on oil for a Vanguard 18 HP Engine? I now have about 10 hours and was going to do the first oil change. Thanks,...

Here's my briggs master mechanic friend racing a Tecumseh twin at Talledega. He's in second place 'till near the end. Was geared a little too low...

2002 bigfoot with 18hp briggs has 147 hours on it. If I give it throttle too fast it bogs down until I let go of the gas. I have to slowly throttle...

I found a Max II today in my area for sale. It has a 16 HP Briggs. I have ridden Mike's with an 18 HP Briggs. I was wondering how much performance...

Hello, I'm working on an argo bigfoot, 1999 I think, 18hp, it idles great, but starts hiccuping and low on power when you try to get it moving,...

Just found this. Kohlers new motor the ch 1000, 40hp 61.5 ft pounds of torque @ 2800 rpms. That should get something moving.:D

I purchased a scrambler with the 8 hp motor a few weeks ago. Since then I have found due to some pretty bad jerry rigging of the fuel system and...

In conjunction with the T-20 evacuating question, here's one for draining the oil. The drain plug on the Kohler in the Buffalo is located on the...

Really need a new motor while I have the transmission out and everything disconnected. Found New! 570cc Briggs Vanguard OHV Engine-LP/NG 1" shaft...

Kawasaki Engine 23hp Horizonal Shaft RUNS!

Has anyone put the new 35 hp briggs in their max at all and how did it go.

Quick question, after setting the engine up it ran great, now on the high rpms it backfires, only now and then, only high rpm. It's a sachs 290 with...

Would take a large amount of batteries, and be far less convinient than gas. be very quiet though. Think I would wire in GFI though to be safe.

Maybe put four in the back of my 8 wheeler?