Forum: Transmissions

Is there a trick to installing the U channels with Richards bands? I can barely get a thread or two started and there's no way the adjustment tool...

I just got a Hustler and unfortunately there is no tranny in it. Having looked and looked for an (affordable) T20 I've come to the conclusion that...

Hey folks. I?m putting a new engine in my conquest and can?t find in the manual info on the offset/ belt deflection, distance etc. If anyone...

Hey so what is everyone running for trans oil? specifically older argos? I've just been using run of the mill 75w90 with a bit ( mabey 10%) of lucas...

Does anyone have a Max IV T20 handy that could verify the total thickness of the two washers used to space the driven clutch. I?m having trouble...

Very frustrating. The secondary clutch center bolt rattled loose again, causing the clutch to wobble under pressure of driving, making the center...

Hi. When we were out riding our Max IV, the smell of burnt atf could be smelled coming from the engine compartment. The engine and trans did get...

can anyone tell me if there is another source besides richard's for purchasing a re-built t-20? thanks for any help

Rather unusual question, but what steel is the T20 input shaft made of? I intend to buy another used shaft, cut the clutch-end off and have it...

i have a chaparral early 70s model, had a jlo 295 in it. did these have reverse originally? if so can someone take a picture of the there linkage and...

2012 Frontier carb model. Only 100 hours. Trans issue. I?ve just noticed an issue when changing gears. I stop, shift into neutral to idle or...

So, when I bought my 1996 Max IV, it was in pieces. Actually, worse than pieces. One of the previous owners had made it into a hydraulic machine. ...

Hi just wondering if anyone on here knows where to find, or mabey has a couple older brake rotors for sale? I've got worn down teeth on mine and am...

Hi all, So I was looking on here for drive belt numbers for a Max, but never came up with a manufacture number, rather a supplier part number. Not...

How hard is it ? Anything to consider ? I have some noise from it turning left. Oil is greyish. Are there rebuild kits ? Thanks

Hi. A problem I've had with the T20, several times now, is the shaft that the secondary clutch rides on is too short. When the mounting bolt rattles...