Forum: Transmissions

I found this page online, and to be honest I was guessing at my belt tension. I figured you tighten it till the machine creeps, then back it off a...

Looks like ill be needing the plungers for my t-20 for my hustler,looks like previous owner tried a rebuild and drove them out with a screwdriver and...

Towards the end of Ashtabula weekend I was having trouble climbing hills. Some of the trouble was choke, but that was corrected. The rest was...

How much horsepower can a t-20 handle im building a machine with hopes of dropping in a 700 wildcat motor in it for sand drags??

looking for some help have a 1983 argo with a 17 hp kohler and its driver clutch is shot beyon any repair need a new one its a 1190 salbury they dont...

Hey Folks; I have a question about my B-H 7000 and that is this trans. even though not under power yet, I thought I should be able to spin this thing...

I looking for someone who would be interested in rebuilding my T20 near Maryland. i have the parts but no time.

I have an early big max that had the 2 cylinder 2-stroke engine. It ran ok strong with a scary top speed but was very finnicky with the carb and no...

:hmmmm2:how do you get the belt off a Baker Hill 7000 in an attex ST/300/D the belt I have on there is too skinny im sure I would figure it out I...

i have just recently purchased my first 6x6 it is a 1970 seirra trail boss my question is what kind of transmission fluid do i use in it and how...

I have a T-20 in my Hustler and it had been working OK until the other day when reverse gear stopped working on the clutch side of the tranny. The...

So, I was just getting ready for bed the other night, and the phone rings (10:30pm). A friend is on the line, and he tells me that he is broke down...

I just finished a T20 rebuild and it was fairly easy, There were a few moments of frustration and swearing. However the adjustments seems to have...

Good morning everyone, I am new to the forum/site. I have a 2002 Max IV. Was having some issues with steering left so I decided to do some...

for the first time i just re-built my t-20 in my max IV. must say, as a newbie, it looked harder than it was as so many of you have posted. having a...

Does anyone know offhand the distance center to center of the rt & lf output sprockets? I'm attempting to re-set the trans mounts in my Hustler...

Finally making progress on an old Attex with a 6000 transmission. Engine running fairly well, new chains, tires that hold air for an hour or two and...

Hi as i mentioned i have stripped the trans to locate source of silver colouring Back ground is that i have not owned the t20 very long so i...