Forum: Transmissions

My 93 Max IV goes forward with no problem but in reverse the left side doesn't work but the right side works well. My question is it is possible to...

I have been taking apart an older t-20 out of an Attex, the ones with the brake rotors on em, and I have noticed some variation from your t-20...

Does anyone know where to find a complete rebuild kit for a t20? I was trailing yesterday and was coming back to truck going down a paved road and i...

Ok fellas, I need some opinions. My 2000 Max had about 10 hours total on it when I bought it in the spring. I took it out for about two hours a few...

I did not see a "resources" directory where we could post names of businesses, etc. that are beneficial to 6x6 restoration, i.e. Richard's Relics,...

I was having problems getting my tranny adjusted properly and had thought about buying the clutch tools that RR sells for $25.00 a pair. Instead I...

I have a t-20 in my 1973 attex and had pulled it out of my machine chained the fluid in it and put it back into my machine. After letting it sit...

I finally rebuilt the T-20 yesterday and finished installing it into the Hustler. Added all the chains and adjusters. Connected the drive rods to...

I purchased a new clutch and installed it. I think the belt was too tight. Anyway, now my transmission is making an awful rattle sound -- even in...

looking to swap out a blown GU transmission in my 99` conquest 8x8 to a CGK transmission from a 89` KB 8x8....will the CGK drop in with no mods. and...

I thought my transmission might have worn bands so I took it out and apart. Everything looks fine, but getting the plungers adjusted seems difficult...

I am an excited new owner of an ATTEX 6x6. Always wanted one, but never could find a good enough deal to allow it. The other day cruising through...

hi! my argos clutch from the engines output shaft is sticking. when i give it gas in will rev up to maybe 5500rpm and then i can see the clutch just...

I just dove into my 4th T-20 rebuild of the summer. looks like this one sat parked on a side hill with the right side down for a long time!...

I got a 196? pug with a 12 briggs&stratton it has no driver cutch on the motor its a 1inch shaft with a 1/4 keyway been looking at clutches on...