Forum: Hustler ATVs

I looked at a hustler today and it had a poly tank. Will it fit where a aluminum tank once was? Filler holes in the same place? Was it only certain...

I'm curious as to how many owners use the optional 5.5" spacers. Do you run your Hustler using the 5.5" spacers?

Hey guys. Here is the new beast: Unsure about the year, I believe it is a 950. Apparently you can put a 980 lower on it to get more room...

I picked up this gas cap. It works perfectly. 1/4 turn seal, perfect dept just off the bottom. It's a Kelch cap. I got it from a company called...

Well its been almost two months or so since Cbass and I first picked up my 980 Hustler from Ark. Needless to say, there were many battles that the...

21x11x8 900 h?

Im lookin at gettin a hustler but i dont know what model it is i think a 950 is what it is it suppose to not have the original motor he said its a...

can you put a 950 frame in a 980 body,i no the seat rails have to be taller but what about the axel spaceing.

Figured I better start posting pictures of this build and the mods I plan on making.

I totally rebuilt my hustler 950 and where the hardened bolts pass through the gear collars, holding them in position on the axles. There's slop or...

I have a hustler 950 it has the 21'' tires what is the largest tire it will take?

Anyone ever install or know someone who installed a harbor freight 420cc predator into a hustler?

Can anyone tell me the t20 clutch size for a hustler 980? Mine is bad and i want to just replace it but i want to make sure i get the right bore size.

Just bought a hustler not sure of year it has a 18hp briggs and a t20 trans any idea of year and model?

Looking at the threaded protruding bolt positions in the picture where they extend through the tub. Do all Hustler's have these mounting bolts...

I have a hustler 980 and i am not sure of the year i know it is between 1980-1985 and i need to know the part # for the belt. I hope they are the...

Finally i'm a proud owner of a 980 bigfoot. Cbass and i had to go a good little ways to get it from ga, but i have her now! Its been not quite 6...

I took the hustler out today. It floats and that anti-seize I put on the axles when I put them through the outer bearings. Worked fine. Not a drop of...